It would be best if you gave us the error messages you get.
Most likely, your drive does not support buffer underflow protection. This is especially likely if the drive is more than two years old.
You may also want to check your copy of Nero and make sure you have buffer underflow protection set. When you go into a new compilation, click the Burn tab and make sure Buffer underrun protection is CHECKED.
Also in that tab, make sure the write speed is not set any higher than the max write speed of your drive; you may even want to knock it down to the next lowest speed.
Finally, if you don't mind the write taking a bit longer, on the Burn tab, check ON "Determine maximum speed."
There are other things this could be. Again, without a specific error message, it is impossible to resolve your question authoritatively. Content provided by Yahoo Answers.
|